Categories
Uncategorized

Sensor Boxes and Controller Box

Laser-cut enclosures for sensors and other things…

Here’s a few photos of a project I recently worked on for Stamm Media and No Small Magic. These are sensor boxes that were used for a tradeshow. I don’t know how much I can say about the tech inside them, but this is what they look like.

I designed, laser cut, and assembled all the boxes. They are partially glued together but the back covers are held on with screws so as to be accessible for adjustment purposes.

This is the final product from last month’s blog post Enclosure Prototyping. Since I finished this piece first I actually added a bit of shellac to it, which makes it just a bit nicer than raw wood. (I ended up making two of these.)

The sensor boxes connect to the control box using Cat5 cable and the RJ45 Adapter Boards I developed last year. This allows for the sensors to be easily placed quite a distance from the control box by just using an existing Cat5 cable instead of needing a custom cable/connector.

Leave a Reply

Your email address will not be published. Required fields are marked *