posts tagged with the keyword ‘cyc’

2017.01.04

CNC Machine

Hopefully you’ve read Little CNC Milling Machine (Part I) in which I completed the mechanical build of a tiny CNC machine. Here’s Part II!

CNC Machine Electronics

The electronics didn’t take much time at all, it was pretty much “plug and play” as far as connecting the three stepper motors and the spindle. No stripping, cutting or crimping wires. The only issue I had was once I tried running it nothing was happening. Turns out the power supply was DOA. I found a 16 volt laptop power supply in my junk bin and tried that, and it still didn’t work (or so I thought.) I ended up cutting the barrel jack off that power supply and putting it on a 24 volt supply I found. It was then I realized that the spindle wasn’t responding because I never set the “spindle speed”. So yeah, steppers worked fine with the 16 volt power supply (but not the original 24 volt supply I got) but the spindle didn’t go, because I’m a fool. All good now! I’ve got functioning 24 volt power supply and a functioning CNC machine.

CNC Machine Electronics

I’ve used Grbl before, usually with an Arduino and a CNC Shield with some steppers. Some of these kits seem to use an Arduino Nano, but this one is its own board with an ATmega328P and a CH340 chip. So yeah, an Arduino with Grbl 0.9 pre-loaded.

There are no endstops, but it looks like there’s room on the board to add them in the future. I can think of a few other improvements as well. I may add an e-stop, or just an “on/off” switch for the power supply. One nice thing about these machines is that if you make a mistake, like jogging the head too far in one direction, you can just cut power to the motors and the software will keep going, assuming the motors are moving, and then once the software is done, you can resupply power and try again.

Oh, you might also notice that next to the spindle connector on the board is a spot to plug in the laser. Yes, there’s also a 500mw laser that can be put in place of the spindle. I’ve not really tried that yet, and have to figure out the software to control it first. (I’ll get into software in a future post.)

CNC Machine Bed

Another area that could use some improvement is the bed. Attaching things with the screws meant to attach things to the Aluminum extrusion is not great. I’ll work on a better clamping system. (Maybe a 3D printed piece, not sure yet.)

You might also notice I left the lead screws hanging in mid-air. I did have a little bit of a binding issue with the x axis, so I just removed both lead screw holders. I think it’ll work fine without them, as the lead screws are not that long.

CNC Machine Collet

The machine came with two tiny collets that allow you to attach bits to the spindle shaft. It also came with super-small set screws. I’m pretty sure I’ll lose the screws, but…

M3 Set Screws

…luckily a few years ago my friends at Evil Mad Scientist Laboratories sent me a lifetime supply of M3 set screws of various sizes. I think I’m good!
}

CNC Machine Electronics

And yes, I did actually mill something. I’ll cover that in the next post. Overall I have to say I’ve been pleased with this machine (so far, it’s still early, obviously.) It was easy to put together and it works. Once I get things dialed in I’ll look into milling PCBs, and foam, and wax, and chocolate…

Stay Tuned!

|


buy the button:

Buy The Button