In a post from a year ago (Bike Light – Downtube – White LED Strip) I ended musing about using COB LED strips for a downtube bike light. Well, I wasted about 10 months thinking about it then had to build it before DST hit.
Since the whole thing was a rush job I don’t have a lot of good photos but I’ll share what I’ve got.
I decided on a shorter strip because the old one was a little long and blocked the charging port. I made it about the right size to print just two pieces of plastic on a 256mm x 256mm print bed.
The strips have adhesive backing so I just had to stick them down to the plastic and solder two wires in place since I was running one single strip at 5 volt from a USB power bank.
I cut a USB cable just the right length and soldered that in place to power the strip. I don’t have a photo of it but I added a giant glob of hot glue one assembled to make it waterproof. I also glued both pieces together so there’s no easy way to open and repair this. (It shouldn’t need repairs as there’s not much in there.)
For attaching it to my bike I just used some adhesive hook & loop with one side stuck to the ebike battery and the other to the COB LED strip. This makes it really easy to attach and remove. No straps to worry about. Stick it on, peel it off.
The USB cable is just the right length to run up to the handlebar bag where I have the USB power bank I use to power my 6 year old phone with a crappy battery.
I think it’s just as bright as the old one, but it is a little shorter, so there’s less light at the end that is closer to the pavement, but it definitely does light things up.
I’m happy with how this turned out. I may try to build another one in the future. I could probably do a strip that is 3-wide. It’ll suck a little more battery but I have about 6 powerbanks and I can usually get two days out of one with plenty to spare before the next charge.
Note: This post may contain Affiliate Links. Read More.
