Categories
Uncategorized

Wire Holder

A holder to hold wire like a pencil cup holds pencils…

I made a Wire Holder. It’s like a pen holder/pencil cup but for wire of a specific length. It’s difficult to tip it over, especially if you use a high infill. Just visit PrusaPrinters to grab the files for the Wire Holder. (There’s an STL file and an OpenSCAD file available.)

I printed this on my old Monoprice Maker Select Plus, which explains the (poor) print quality. If I had printed it on the Prusa, I’m sure it would look much better. It doesn’t really need to look good though… it works, that’s what matters. (The Prusa was busy printing something more important at the time.)

Also, yes, I know… but this is for wire of a specific length.