Last year I wrote up Syncing a Behringer RD-6 to a Pocket Operator via a Pi Pico which was more of a “wow, this works!” thing than a good explanation. I say that because a few people thought it was nice, but didn’t quite understand it, or wanted a diagram, so here’s a diagram…
The 1/8″ stereo jack on the left is where you plug in the Pocket Operator, and the 1/8″ stereo jack on the right goes to the device you want to sync up. (A Behringer RD-6 or TD-3 for example.) The ring/red is the audio side of things, the tip/orange is the click/sync signal put out by the PO, and sleeve/black is the common ground.
As previously mentioned, the Pocket Operators are awesome, and they can sync with each other, but can’t always sync with other devices. They put out a 1 volt signal for the sync track (the “click”) and most other electronic devices want something higher, like 2.5 volts, or 5 volts. The Behringer RD-6 wants over 2.5 volts, so you cannot sync it to a Pocket Operator, but now you can with this device!
This basically reads the 1 volt from the Pocket Operator, and then outputs 5 volts (or 3 volts depending on your microcontroller) that the Behringer RD-6 can recognize as a sync in signal. While the RD-6 has a sync out port, there are reasons you may want to have the PO be the primary and the RD-6 be the secondary. There’s also the Behringer TD-3, which (oddly enough) does not have a sync out port.
A guy named Oscar got in touch and asked if this worked with the TD-3 and at the time I didn’t have one. Well, I have one now, and it works great. And since the TD-3 does not have a sync out port (!?!?) this is the only way (without additional hardware) to sync a TD-3 to a PO.
I built one (using a Nano, not an Uno) and I’m sending it to Oscar to test out. He’ll need to provide a USB power source and a splitter cable to get it working. (He’s got both already. Most Pocket Operator nerds probably do.)
I did make one mistake on this device… I actually incorporated labels into the enclosure. I for “In” and O for “Out” and when assembling it I didn’t notice I had it backwards until testing. Oops! So I just stuck some labels on the top, and now In is on the right and Out is on the left. If I make another, I’ll do it right next time. Oh, I also realized I could probably just build a splitter into it by adding another jack, so I may do that as well. (Though that will increase the size of the enclosure a bit.)
